***REFURBISHED***
Rockford Fosgate Power T400-4
4-channel 400 WATT car amplifier
GENERAL FEATURES:
Rockford Fosgate's Power Series amps are top notch, with fine-tuned audio controls, extreme durability, and proprietary technologies that deliver intense, reliable performance over most other amplifiers on the market.
Patented, award-winning "Dynamic Thermal Management," a 3-stage cooling system that uses forced air to dissipate heat evenly across the amp and out through the large heatsinks. This results in cooler internal components, better efficiency, and less distortion.
MEHSA is a Rockford Fosgate proprietary process that increases the heat transfer from the MOSFET devices to the heatsink. This allows the heat to escape more effectively from the amp, so that the transistors stay cooler.
"Differential Input" circuitry helps eliminate any noise or hum that could be electrically detected by the input cables, allowing only clean signals to enter the amplifier. You get more music with less heat and noise in a package that's up to 40% smaller than previous models.
The T400-4 amplifier kicks out 60 watts RMS into each of its 4 channels — more than enough to achieve your best output from your front and rear speakers. Or you can bridge your T400-4 to provide 200 watts each to a pair of subwoofers. One way or another, you can depend on clean, power sound from your Power Series amp.
Features
4-channel car amplifier
CEA-2006 compliant
Dynamic Thermal Management cooling system
Differential Input circuitry eliminates hum
60 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 bridged output at 4 ohms (2-ohm stable in bridged mode)
variable high- and low-pass filters (50-500 Hz, 24 dB/octave)
variable bass/treble boost (0-18 dB at 45 Hz, 0-12 dB at 12k Hz)
optional remote bass/treble boost (available soon)
Class-AB amplifier design
MOSFET power and output stages
preamp inputs
4-gauge power and ground leads and a 100-amp fuse recommended — wiring and hardware not included with amplifier
no on-board fuses — when installing multiple amps in a system, an additional 100-amp in-line fuse between the distribution block and the amplifier is recommended
13-5/8"W x 2-1/4"H x 9-5/8"D